DETERMINATION OF HYDRAULIC ACTIVITY OF QUARTZITE WASTE INDUCTION FURNACES
DOI:
https://doi.org/10.56292/SJFSU/vol31_iss1/a%25pKeywords:
quartzite waste, hydraulic activity, Portland cement, mineral additive, strength, cement–sand mortar.Abstract
The paper investigates the hydraulic activity of quartzite waste from induction furnaces when used in cement–sand mortars. Experimental mixtures were prepared by partially replacing Portland cement with quartzite waste in amounts of 10–30 wt.%. The flexural and compressive strength of the specimens was determined at the ages of 7 and 28 days. It was established that the incorporation of 15–20% quartzite waste leads to an increase in strength compared with the control mixture, which is associated with its participation in hydration processes and the densification of the cement stone structure. An increase in the additive content above 20% results in a decrease in strength due to a reduction in the clinker phase content.
References
1. Саидов И.Р. Влияние микрокремнезёма на структуру и свойства цементных композитов // Строительные материалы. – 2017. – №3. – С. 45–50.
2. Абдуллаев Ш.Х. Исследование влияния шлаковых добавок на характеристики портландцемента // Известия вузов. Строительство. – 2019. – №8. – С. 112–118.
3. Атакузиев Т.А. Технология сульфоминеральных и сульфатсодержащих цементов. – Ташкент: Фан, 2018. – 220 с.
4. Искандарова М. Использование керамического боя как алюмосиликатной добавки в белом портландцементе // Вестник ТГТУ. – 2020. – №2. – С. 34–40.
5. Атабаев Ф.Б., Искандарова М.И. Применение отходов вольфрамовых руд Ингичкинского месторождения в составе портландцемента // Вестник строительства. – 2021. – №6. – С. 96–99.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Scientific journal of the Fergana State University
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
How to Cite
